​​*On lifts incorporating overhead structures, verify the safety shutoff.

*Inspect all chains and wire ropes.

*Reporting unguarded pinch points.

*Confirm single point operation of in-ground lifts.

*Check all accessible piping, tubing, hoses, valves and fittings. Review lift oil consumption records.

*Operate lift through full travel and observe.

*On air-oil lifts check for low oil controls.

*Confirm cylinder venting provisions.

*Confirm rotation prevention device on single post lifts.

*On lifts utilizing pumping units, confirm adequacy of oil level at fully raised position. 

Bay Systems inspects automotive lifts according to the ANSI/ALI ALOIM standards

LIFT INSPECTIONS

In-ground lifts

Bay Systems Inc

phone: 1-619-420-4495  Fax: 1-619-420-4496  SERVICE@BAYSYSTEMSINC.NET

YOUR SERVICE BAY  SOLUTIONS

750 DESIGN CT #108 CHULA VISTA, CA

Inspections Include:

​*Record Location of manufacturer's name, serial number and load capacity.

*Record location of safety instructions & warning labels.

*With lift loaded, stop lift at midpoint travel and observe.

​*Confirm adequacy of clearances around lift.

*Examine all structural components including welds.

*Examine electrical components and wiring.

*Check lift controls.

*Check swing arm restraints and telescopic stops.

*Check all fastening devices for tightness including floor anchor bolts.

*On lifts employing adapters, check condition & proper operation.

*With a representative vehicle on the lift, check the lowering speed of the lift.

*Check all points regarding lubrication.

*Check operation of positive step and lift locks.

*Check lifts equipped with lateral synchronization or equalization systems.


​Upon completing the lift inspection, customers will be provided with the inspection report along with a quotation of any needed repairs.

After passing the ACI inspection the lift will receive an ALI inspection Sticker.